NMEA Cables & Sensors
Rectangular Magnetic Switch for Indoor The 1035 Series magnetic contact saves installation time through the use of a specially formulated 3Mr adhesive tape. The tape, which establishes a permanent bon... More Details
RIM100 Run Indicator Module Part #: RIM100-01 Maretron's Run Indicator Module monitors both AC and DC electrical circuits and reports, over an NMEA 2000 network, whether or not the electrical circuit ... More Details
SIM100 Switch Indicator Module Maretron's Switch Indicator Module monitors switch closure devices including, but not limited to, safety equipment (heat, smoke, carbon monoxide, explosive vapor detecto... More Details
Maretron Solid-State Rate/Gyro Compass w/10m Cable & Connector
NMEA Cables & Sensors, Maretron
$739.80
Solid-State Rate/Gyro Compass w/10m Cable & Connector Maretron's SSC300, implementing the second generation of Maretron's award-wining compass technology, is a solid state, rate gyro electronic compas... More Details
Solid-State Rate/Gyro Compass without Cables Maretron's SSC300, implementing the second generation of Maretron's award-wining compass technology, is a solid state, rate gyro electronic compass that pr... More Details
Submersible Pressure Transducer 0-3 PSI Maretron’s submersible pressure transducers indicate tank levels and can be installed directly in the tank. Please follow these instructions to mount and connec... More Details
The TR3K temperature probe is for use with the Maretron TMP100 Temperature Module (optional extra) or the DCM100 DC Monitor (it is included with the DCM100). This probe ends in a ring terminal and can... More Details
TLA100 NMEA 2000®Tank Level Adapter The TLA100 is used to adapt commercially available resistive tank senders to the NMEA 2000® network. This allows you to observe tank levels anywhere on the vessel w... More Details
The TLM100 is used to sense levels of liquid tanks using ultrasonic technology and transmit the liquid levels over the NMEA 2000 network. This allows you to observe tank levels anywhere on the vessel ... More Details
The TLM150 is used to sense levels of gasoline tanks using ultrasonic technology and transmit the gasoline levels over the NMEA 2000 network. This allows you to observe gasoline tank levels anywhere o... More Details
Maretron's TMP100 measures the temperature for up to 6 temperature probes and reports the information over an NMEA 2000 network. The TMP100 supports up to 4 thermistor probes and 2 high temperature th... More Details
Ultrasonic Wind & Weather Antenna Maretron's outdoor weather station measures wind speed and direction, air temperature, barometric pressure, and relative humidity. The wind measurement is performed u... More Details
USB100 NMEA 2000® / USB Gateway Maretron's USB100 is a gateway for bridging USB equipment using NMEA 0183 sentences - such as an on-board computer running navigational software - with an NMEA 2000® ne... More Details
Water In Fuel Detector Part #: WIF-RK30880-E A WIF-RK30880-E Fuel detector mounted on the bottom of a fuel filter will provide a voltage when water is detected in the fuel. This voltage can be detecte... More Details
SmartFind M15S AIS Class B Receiver/Splitter McMurdo's SmartFind M15S is a low cost receiver that puts AIS technology within the reach of even those on a limited budget. It receives all Class A, Class... More Details
NMEA 2000 Right-Angle Interconnect Cable - Micro-C This right-angle cable is made for connecting to NMEA 2000 displays. The right angle can be useful when making a connection due to its low profile. ... More Details
Backbone Cables In a SeaTalkng installation, a backbone cable runs through the length of the boat. Individual devices connect to the backbone by spur cables that run to T-pieces on the backbone. The b... More Details
Spur Cable Raymarine 1 meter Spur Cable for SeaTalkng More Details
Spur Cable Raymarine 1 meter stripped end Spur Cable for SeaTalkng More Details
Backbone Cables In a SeaTalkng installation, a backbone cable runs through the length of the boat. Individual devices connect to the backbone by spur cables that run to T-pieces on the backbone. The b... More Details
Backbone Cables In a SeaTalkng installation, a backbone cable runs through the length of the boat. Individual devices connect to the backbone by spur cables that run to T-pieces on the backbone. The b... More Details
Spur Cable Raymarine 3 meter Spur Cable for SeaTalkng More Details
Spur Cable Raymarine 3 meter stripped end Spur Cable for SeaTalkng More Details
Backbone Cables In a SeaTalkng installation, a backbone cable runs through the length of the boat. Individual devices connect to the backbone by spur cables that run to T-pieces on the backbone. The b... More Details
Spur Cable Raymarine 400MM elbow Spur Cable for SeaTalkng More Details
Spur Cable Raymarine 400MM Spur Cable for SeaTalkng More Details
Backbone Cables In a SeaTalkng installation, a backbone cable runs through the length of the boat. Individual devices connect to the backbone by spur cables that run to T-pieces on the backbone. The b... More Details
Backbone Cables In a SeaTalkng installation, a backbone cable runs through the length of the boat. Individual devices connect to the backbone by spur cables that run to T-pieces on the backbone. The b... More Details
Autopilot Backbone Cable Kit This autopilot backbone cable kit is required to connect the X-10, X-30, X-CAN and X-SOL corepacks to the ST70 Autopilot Control Head. Kit Includes A06028 - STNG T-piece c... More Details
Raymarine AXIOM Power Cable 1.5M Right Angle & NMEA 2000 Connector
NMEA Cables & Sensors, Raymarine
$75.34
AXIOM Power Cable 1.5M Right Angle & NMEA 2000 Connector Features: AXIOM Power Cable 1.5M Right Angle NMEA 2000 Connector 90° More Details
Blanking Plug f/SeaTalk ng This blanking plug is a blanking plug for the SeaTalkng. Place blanking plug in unused SeaTalkNG Spur sockets to protect them. More Details
Cable Kit NMEA2000 Gateway Cable Kit for NMEA2000 Gateway, MFG# T12217. Consists of 1M ST-ng spur cable, DeviceNet adapter cable, ST-ng 5-way connector, ST-ng power cord, 2 ea. ST-ng terminators. More Details
Raymarine Devicenet Female ADP Cable - SeaTalkng - NMEA 2000
NMEA Cables & Sensors, Raymarine
$68.49
Devicenet Female ADP Cable - SeaTalkng - NMEA 2000 Adapts SeaTalkng to NMEA2000 network. For use with E & C Series Widescreen, G Series, and ST70 systems. Female: 15.7" (0.4m) More Details
Devicenet Male ADP Cable SeaTalkng to NMEA 2000 Adapts SeaTalkng to NMEA2000 network. For use with E & C Series Widescreen, G Series, and ST70 systems. Male: 1.5M cable More Details
SeaTalk 1 to SeaTalkng Converter Kit The SeaTalk 1 to Seatalkng converter allows select SeaTalk 1 devices to interface and communicate on the Raymarine SeaTalkng data network. It is compatible with le... More Details
Evolution Cabling Kit - R70160 The Evolution SeaTalkng cable kit contains: 1 x SeaTalkng Power Cable (0.4m) 1 x SeaTalkng Backbone Cable (5m) 1 x SeaTalkng Spur Cable (0.4m) 1 x SeaTalkng 5-way Connec... More Details
GA200 GPS Sensor for AIS700 The GA200 is an external antenna, suitable for improving the reception of the internal GNSS (GPS / GLONASS) receivers of compatible MFDs, AIS devices, and VHF radios. The G... More Details
Raymarine In-Line Terminator In-Line SeaTalkng Terminator f/Long Cable Runs old part number a80001 , now its a06074 More Details
SeaTalk 2 / NMEA 2000 Interface Cable (1.5m) Interface cable for connecting E-Series displays to Raymarine SeaTalk 2 or 3rd party NMEA 2000 Devices. Twist-lock connector at the E-series display end, a... More Details
Raymarine SeaTalkng Starter Kit SeaTalkng is a robust cabling and connection system compatible with NMEA 2000, built specifically for the marine environment comprising a powered single backbone with t... More Details
5-way SeaTalkng Connector used for connecting spurs to the backbone. More Details
The SeaTalkng Backbone kit contains everything you need to construct and wire a basic SeaTalkng navigation network backbone on board your vessel. The kit contains the following components: A06031 SeaT... More Details
SeaTalkng Backbone Extender for extending blue SeaTalkng Backbone Cables. More Details
SeaTalkng Terminators attach at each end of SeaTalk backbone. Two are required per system. More Details
SeaTalkngT-Piece Connector. Used for connecting white SeaTalkng Spur Cables to Blue SeaTalkng Backbone Cables. More Details
ST-Ng to DeviceNet Female SeaTalkng backbone cable to DeviceNet (Female) - 400mm More Details
ST-Ng to DeviceNet Male SeaTalkng backbone cable to DeviceNet (Male) - 400mm More Details
VHF NMEA0183 To SeaTalkng Converter Kit Raymarine's VHF NMEA0183 to Seatalkng Converter Kit is used for connecting an Isolated NMEA0183 VHF to the SeaTalkng network. More Details
Siren Marine NMEA 2000 Cable & T Connector Connection Kit f/Siren 3 Pro
NMEA Cables & Sensors, Siren Marine
$52.70
NMEA 2000 Cable & T Connector Connection Kit for Siren 3 Pro Optimize the connectivity of your Connected Boat® system, allowing you to monitor engine data, water, fuel and waste tanks, and more! The N... More Details
Veratron NMEA 2000® Kit w/Furukawa Connector (Honda & Tohatsu)
NMEA Cables & Sensors, Veratron
$538.70
You save:
$59.85
NMEA 2000® Kit with Furukawa Connector (Honda & Tohatsu) Features: NMEA 2000® Power cable (A2C3931290001) T-splitters (A2C3931270002) 6M NMEA drop cable with Furukawa connector (B00134601) Male (A2C39... More Details
