On in parenthesis (On) indicates a momentary position.... More Details

On in parenthesis (On) indicates a momentary position.... More Details

On in parenthesis (On) indicates a momentary position.... More Details

Type FD (deep). Molded ridge around face further prevents water from getting between box and cover plate. 4-9/16" high x 2-15/16" wide x 3-1/4" deep. Has a 22 cubic inch capacity.... More Details

Yellow Supertough® nylon. Shore power inlet has gasketed, spring loaded cover which closes automatically when not in use and is watertight when securely fastened. Mounting holes are 4-7/8" on centers ... More Details

Black silicone rubber bonded to brass nut. Provides positive seal against moisture, oil, etc. Fits any non-lighted toggle switch.... More Details

Yellow Zytel® super tough nylon watertight plug has gasketed locking ring to make plug/receptacle interface watertight. Cord grip range is 1.00-1.94 in. (25.4-49.3).... More Details

Yellow Zytel® super tough nylon watertight plug has gasketed locking ring to make plug/receptacle interface watertight. Cord grip range is 1.00-1.94 in. (25.4-49.3).... More Details

More Details

Stainless steel power outlet has gasketed, self-closing cover, watertight when cover is screwed in place. Mounting holes are 2-3/8" (60.3) on centers. Mounting screws and gasket included.... More Details

Yellow Supertough® nylon watertight connector body has gasketed locking ring to make inlet/connector interface watertight. Cord grip range is 1.000-1.940" (25.4-49.3).This device mates with shore powe... More Details

Yellow Supertough® nylon watertight connector body has gasketed locking ring to make inlet/connector interface watertight. Cord grip range is 1.000-1.940" (25.4-49.3).This device mates with shore powe... More Details

Gray Supertough® nylon dockside receptacle has gasketed, spring-loaded cover. Closes automatically when not in use and is watertight when securely fastened. Mounting holes are 4-7/8" (123.8) on center... More Details

Gray Supertough® nylon dockside receptacle has gasketed, spring-loaded cover. Closes automatically when not in use and is watertight when securely fastened. Mounting holes are 4-7/8" (123.8) on center... More Details

Provides secure mounting means. Ears at top and bottom pull box tightly against wall. Support strap is provided which pulls box to backside of wall.... More Details

Interior has easy-to-wire terminations and is transparent for quick and easy visual inspection. Mounting holes are 2-3/8" on centers. Mounting screws, gasket and protective rear enclosure is included.... More Details

More Details

Safely powers 50 amp 125/250 volt boat from (2) 30 amp 125 volt receptacles at dockside. 4-pole contactor breaks both hots and both neutrals to prevent possible "live" plug when not engaged. UV resist... More Details

Fully molded water tight design.... More Details

Fully molded water tight design.... More Details

Fully molded water tight design.... More Details

Mounting holes are 2-3/8" on centers and match existing mounting patterns. Mounting screws and gasket included.SS models have a gasketed, self-closing cover, making it watertight when fastened.... More Details

50 Amp, 125/250 Volt. Nickel plated brass. Heat resistant thermoset interior and combination metal and rubber cord grip, which provides superior strain relief capability. Cord grip range is .44-1.140"... More Details

50 Amp, 125/250 Volt. Nickel plated brass. Heat resistant thermoset interior and combination metal and rubber cord grip, which provides superior strain relief capability. Cord grip range is .44-1.140"... More Details

50 Amp, 125/250 Volt. Nickel plated brass. Heat resistant thermoset interior and combination metal and rubber cord grip, which provides superior strain relief capability. Cord grip range is .44-1.140"... More Details

50 Amp, 125/250 Volt. Nickel plated brass. Heat resistant thermoset interior and combination metal and rubber cord grip, which provides superior strain relief capability. Cord grip range is .44-1.140"... More Details

Isolation Transformers for the Marine industry. Suitable for 100 Amp shore power systems, UL Listed isolation transformers assure proper wiring conditions on your boat, and greatly minimizes the possi... More Details

Features heat resistant thermoset base.... More Details

Features heat resistant thermoset base.... More Details

Styled and sized like a standard Hubbell Twist-Lock® Plug. Simply plug it in and the LED back panel immediately identifies if the connections are made correctly and are in the correct position, ensuri... More Details

Valox® carbonate. For weatherproofing 50 amp receptacles. Meets the requirements of the most stringent of UL's three listing categories for weatherproof plates. Stainless steel screws and a neoprene g... More Details

For weatherproofing connector bodies when used on extension cords or adapters.... More Details

More Details

For weatherproofing 50 amp plugs... More Details

More Details

For connector bodies when used with shore power inlets. Stainless steel threaded sealing ring makes connection watertight.... More Details

White polycarbonate. Spring loaded. For weatherproofing 26CM10 receptacle. Meets the most stringent requirements of UL's three listing categories for weatherproof plates. Stainless steel screws and ne... More Details

Yellow polycarbonate. Spring loaded. For weatherproofing 26CM10 receptacle. Meets the most stringent requirements of UL's three listing categories for weatherproof plates. Stainless steel screws and n... More Details

Yellow polycarbonate. Spring loaded. For weatherproofing old style 26CM10 receptacle. Meets the most stringent requirements of UL's three listing categories for weatherproof plates. Stainless steel sc... More Details

Fully molded, watertight design.... More Details

Fully molded, watertight design.... More Details

Compact Grey nylon panel mount inlet ideal for bass boat battery charging connection. Has gasketed spring-loaded lift cover for weatherproofing front and neoprene boot for weatherproofing rear. Will a... More Details

Fully molded, watertight design.... More Details

Fully molded, watertight design.... More Details

Vinyl jacketed. Completely factory pre-wired with molded-on devices. Connector end has a threaded sealing ring for making the inlet/connector interface watertight.LED models have two high density LED ... More Details

More Details

More Details

For 26CM13 connector body when used with shore power inlets. Yellow. Threaded sealing ring makes connection watertight. Also for weatherproofing 26CM11 plug when used with 60CM63 power outlet. Fits In... More Details

For weatherproofing 26CM11 plugFits Insulgrip® devices onlyYellow... More Details

Rugged nylon housing and detachable cord grip (range .230-.720") that utilizes unique offset jaws arrangement to provide secure strain relief. Yellow15 Amp 125 Volt... More Details

Rugged nylon housing and detachable cord grip (range .230-.720") that utilizes unique offset jaws arrangement to provide secure strain relief. Yellow15 Amp 125 Volt... More Details

Features heat resistant melamine body and abuse resistant nylon face. Use where salt or other corrosive elements are a problemYellow corrosion resistant duplex receptacle15 Amp 125 Volt... More Details

Spring-loaded polycarbonate. For weatherproofing duplex receptacles. Stainless steel screws. Neoprene gasket. For FS/FD type weatherproof boxes.... More Details

A simple arrangement of neon lights which visually indicates correct wiring, reverse polarity, open ground, neutral or hot wire, hot and ground reversed, hot wire on neutral terminal and hot terminal ... More Details

Until now, larger electric fishing reel systems typically utilized AC rated corrosion resistant connectors since there were no DC rated devices. Hubbell's DC rated locking electric fishing reel system... More Details

More Details

Until now, larger electric fishing reel systems typically utilized AC rated corrosion resistant connectors since there were no DC rated devices. Hubbell's DC rated locking electric fishing reel system... More Details

Until now, larger electric fishing reel systems typically utilized AC rated corrosion resistant connectors since there were no DC rated devices. Hubbell's DC rated locking electric fishing reel system... More Details

Permits use of 15 amp or 20 amp 125 volt straight blade plug with 30 amp 125 volt twist-lock locking type receptacle. Not recommended for use in wet locations.... More Details

Permits use of 30 amp 125 volt twist-lock locking type plug with 15 amp 125 volt straight blade receptacle. Not UL listed. Not recommended for use in wet locations.... More Details

Yellow melamine with all nickel plated components, back wired.... More Details

Yellow nylon body, nickel plated contacts, triple grip nylon cord clamp, individual wire pockets for easy wire terminations.... More Details

Yellow nylon body, nickel plated contacts, triple grip nylon cord clamp, individual wire pockets for easy wire terminations.... More Details

Stainless steel power outlet has gasketed, self-closing cover, watertight when cover is screwed in place. Mounting holes are 2-3/8" (60.3) on centers. Mounting screws and gasket included.... More Details

Interior has easy-to-wire terminations and is transparent for quick and easy visual inspection. Mounting holes are 2-3/8" on centers. Mounting screws, gasket and protective rear enclosure is included.... More Details

Rugged nylon housing and cord grip (range .385-.780") that utilizes unique offset jaws arrangement to provide secure strain relief.Yellow30 Amp 125 Volt Twist-Lock®... More Details

Rugged nylon housing and cord grip (range .385-.780") that utilizes unique offset jaws arrangement to provide secure strain relief.Yellow30 Amp 125 Volt Twist-Lock®... More Details

Single receptacle has heat resistant Rynite° body and abuse resistant nylon face.... More Details

Permits use of 15 amp or 20 amp 125 volt straight blade plug with 20 amp 125 volt twist-lock locking type receptacle. Not recommended for use in wet locations.... More Details

30 amp Twist-Lock to 15 amp straight blade adapter with GFCI. Now you can plug in your power drill, sander or any other 15 amp tool or appliance into that 30 amp outlet on the dock. Features manual re... More Details

Fully molded, watertight design.... More Details

Fully molded, watertight design.... More Details

For ground fault receptacles and stylized receptacles. For vertical mounting in standard or FS/FD type boxes. PVC.... More Details

For ground fault receptacles and stylized receptacles. For vertical mounting in standard or FS/FD type boxes. PVC.... More Details

Vinyl jacketed. Completely factory pre-wired with molded-on devices. Connector end has a threaded sealing ring for making the inlet/connector interface watertight.LED models have two high density LED ... More Details

Vinyl jacketed. Completely factory pre-wired with molded-on devices. Connector end has a threaded sealing ring for making the inlet/connector interface watertight.LED models have two high density LED ... More Details

Mounting holes are 2-3/8" on centers and match existing mounting patterns. Mounting screws and gasket included.SS models have a gasketed, self-closing cover, making it watertight when fastened.... More Details

Mounting holes are 2-3/8" on centers and match existing mounting patterns. Mounting screws and gasket included.Non-metallic (NM) models feature a UV resistant white cover which make the unit weatherpr... More Details

Vinyl jacketed. Completely factory pre-wired with molded on devices. Connector end has non-metallic threaded sealing ring which makes inlet/connector interface watertight.... More Details

Vinyl jacketed. Completely factory pre-wired with molded on devices. Connector end has non-metallic threaded sealing ring which makes inlet/connector interface watertight.... More Details

Type FD (deep). Molded ridge around face further prevents water from getting between box and cover plate. 4-9/16" high x 2-15/16" wide x 3-1/4" deep. Has a 22 cubic inch capacity.... More Details

Hubbell's GFCI receptacles can be mounted on any standard 2.50" (63.5) deep box. A feed-thru feature provides protection not only at that receptacle but also at any other receptacle located downstream... More Details

Hubbell's GFCI receptacles can be mounted on any standard 2.50" (63.5) deep box. A feed-thru feature provides protection not only at that receptacle but also at any other receptacle located downstream... More Details

Hubbell's GFCI receptacles can be mounted on any standard 2.50" (63.5) deep box. A feed-thru feature provides protection not only at that receptacle but also at any other receptacle located downstream... More Details